EMP Safety Training
Independent preparedness guides. Not a certification or training course.

How to get water from a well without power

Last checked 2026-11-21 · sources at the bottom of the page
Short answer: Many private wells use an electric pump, and your well contractor can confirm whether yours does. If it does, a power outage means no running water from the tap. The CDC says a generator may run a well if it is properly sized. It also says that if a well loses pressure, the water should not be drunk until it has been tested, and that well disinfection should be done by a well or pump contractor. The first and cheapest step is stored water.

Why does a well stop working in an outage?

A private well typically has a pump that moves water to the house and holds pressure in the plumbing. That pump runs on electricity. Without power it does not run. The details depend on your well and pump, and we found no official source that describes every setup, so the specifics are unknown here. Your well contractor can tell you what type you have.

What are the options?

OptionWhat it meansWho should do it
Stored waterWater you filled and sealed before the outage. Works with no equipment. See how much water to store per person.You
Generator sized for the pumpThe CDC says a generator may run the well if properly sized, and never to use one inside, even with doors and windows open. Sizing the generator and connecting it to the pump circuit is electrical work.A licensed electrician or well contractor
Manual pumpA hand pump installed in or beside the well. Whether one fits depends on the well. We have no official source on which wells allow one.A well contractor
BailerA weighted tube lowered on a rope to lift water by hand. It can work in some drilled wells. The CDC page on disinfecting wells mentions pumping or bailing out water, but we did not find an official source on which wells suit a bailer.A well contractor, to confirm it fits

We give no brands, prices, depths or flow rates. The pages we opened do not give them, and they vary by well.

What does the CDC say about contamination when pressure is lost?

The CDC's private wells page on wells after a wildfire says to determine whether the well lost pressure if the home lost power, and that this matters even if power is now back on. It says spurting water indicates a loss of pressure in the well and the household plumbing. If pressure was lost, it says not to drink the water until it is tested, and to prime the pump, then disinfect and flush the well. It says to test for bacteria at a minimum. That page is written for wildfire aftermath. We have not found an official page on pressure loss from an ordinary outage, so how often pressure loss in an outage leads to contamination is unknown.

The CDC's page on disinfecting wells after an emergency says that if extensive flooding has occurred or you suspect the well is contaminated, do not drink the water. It says water contaminated with fuel or toxic chemicals will not be made safe by boiling or disinfection.

Who should disinfect a well?

The CDC says wells should be disinfected by a well or pump contractor, due to safety concerns. It says to turn off all electricity to the well area before clearing debris, and that a qualified electrician, well contractor or pump contractor should check the wiring before power is restored. Its steps include letting the solution sit for at least 12 hours, and waiting at least 7 to 10 days before sampling for total coliform and E. coli. It also advises drinking bottled water until you are sure your water is safe. Follow the CDC page itself for the full procedure, and do not rely on this summary.

What we do not know

What to do about it

  1. Store water first, using the household count and the amounts on the storage page.
  2. Ask a well contractor now, not during an outage, what pump you have, whether a manual pump or bailer fits, and what generator size it needs. Hire a licensed electrician for any connection to the home's wiring.
  3. If the power went out and came back, check the CDC's pressure signs before drinking from the well, and get the water tested.
  4. Learn the treatment steps in how to make water safe to drink without power, and remember they do not remove chemicals.
  5. Consider what to look for in backup power, and run any generator outdoors.

Sources

  1. Centers for Disease Control and Prevention, "Private wells after a wildfire," opened 2026-11-21: cdc.gov
  2. Centers for Disease Control and Prevention, "How to Disinfect Wells After an Emergency," opened 2026-11-21: cdc.gov